.

.

.

May 2, 2022 · In Altium Designer, you can define how vias and pads connect to polygons with a design rule. There is no other polygon.

.

Some of the footprints of the same type causes short circuit but other don't.

Select the required net in the Connect to Net drop-down in the Properties panel. To do this, select Place » Polygon Pour and use the mouse to draw a polygon outline that should cover vias connected to the VCC_3. I noticed that some of the vias look like the following, where blue is the GND polygon, and the GND net via does not connect to it at all.

The first thing that you should do in your Altium PCB layout session is to make sure that your polygon preferences are set up.

Apr 12, 2022 · Connecting the Polygon to a Net. . You might place a fill on the same layer to "bridge" between the polygon and a same-net object you want the polygon to stop being bashful about connecting.

When we define clearance rule for same net objects we get violation for everything (even the track connections and track leaving the via connection is now a violation as can be seen from the picture 3 & 4) including the case mentioned above. fc-smoke">Apr 12, 2022 · Connecting the Polygon to a Net.

.

Setting Up and Running a Health Check.

. The first thing that you should do in your Altium PCB layout session is to make sure that your polygon preferences are set up.

Both polygons are set to "pour over all same net objects". exe.

The “Preferences” menu can be found by going to the bottom of the “Tools”.
The first thing that you should do in your Altium PCB layout session is to make sure that your polygon preferences are set up.
You can keep working with your project or open it from the Workspace and continue from where the previous step is completed.

.

After launching the command, click on.

I just. Available checks are listed in the grid area of. exe from the same task manager (almost instant, rather than 30+ seconds).

. The first thing that you should do in your Altium PCB layout session is to make sure that your polygon preferences are set up. All fanout vias and connecting track will be placed outside of the. . . May 3, 2023 · Create Solid Polygons - enable this option to ensure polygons (copper pours) are created when exporting CAM Editor designs.

.

Available. Select the polygon and look to the properties panel.

Thanks! tuncsahin • 4 yr.

Hatched Polygon Options - click to set up the hatched polygon such as the grid size, track width, minimum primitive length, and removing dead copper when.

All checks are grouped by relevant categories (Regions, Polygons, Components, etc.

All fanout vias and connecting track will be placed within the component's bounding rectangle.

ago.